How to add a leaf spring

There are several different methods to improve the height of the rear truck. ph meter Most cost-effective and efficient way is to add one of the existing leaf spring service objectives. The first is to increase the body height, the other is the spring to increase your ability to make your long distance and tow more weight, orp meter the ability of the tail drooping. Command, you should know that adding a long-term and short-term there are leaves with two different styles. One leaf, usually your second or third new leaf; short-term leaves add to the overload spring from above the bottom of the second one. My next article, I will describe the differences between these two styles, but I will tell you to add long-leaf is a better product, ph/orp controller you should install in your vehicle at short. It is worth noting that to find long-term added at the end of the tips into a leaf, because nothing is more annoying than to do the job, every time you go to a bump irritating squeak. salt meter Therefore, no further long-term ADO here to add leaves, remember that all vehicles are set different, so these are typical, but the difference is likely to command. Made on the height you need to jack the rear axle, then put jack stands under the frame. Stands under the jack stand, leaf springs jack until frame support. In this process, remove the tire is optional. Some people think that it is easier, but for me personally, just add more time-consuming process.
Still support the axle with jack U-bolts and remove the lower shock bolt. Down jack, so a few inches of the bridge, which will take off the load and the leaf spring to your room, in the new leaf spring center bolt from the separation. REBAR BENDER Since this is a curved blade you need to add a clip of your plants, so you can insert your new leaf-inch channel lock pliers or pipe wrench, turn the clip so the factory instructions. Note - a lot of added leaf pack replacement clip, so if you do not use them for another leaf. In this case, if your old clips must be removed, drilling, input shaft and gear grinding, or torch. Remove the leaf spring center bolt. You may want to exchange pliers or vice grips, so the spring will not "explode", the center bolt is removed. As you probably now the main truck leaves still hanging on, High temperature gate valve remove the rest of the spring and stack them with new center bolts. Spring will remain in staggered formation, so the top and shorter as they go down the longest leaf, insert you add leaves. LCL